Modwright KWH 225i Integrated Amplifier
Hybrid Integrated Amplifier
"The results were clear: the KWH 225i took the incoming sources with ease, and made the Sopra Ones stand at attention, despite their middling efficiency. No tap-out; no pooping out. The high bandwidth of the 225i (20Hz – 100kHz at 0dB) provided excellent extension and a great sense of presence, especially with DSD128 and DSD256. I loved the dynamics of the 225i; it has real punch, with killer quickness." - David Robinson, PFO
"We combined solid state output stage of our Reference KWA 150SE amp, with the controls and integration of the KWI 200. We then replaced the SS preamp circuit with a Class A tube design and increased the power to 225W. The result is the KWH 225i." - Dan Wright
- 25 watts Class A
- 225 Watts Class A/B
- Zero Negative Feedback Solid State Amplifier
- 6922 Tube Based Preamplifier
Hybrid Design In Modwright's DNA
The Modwright KWH 225i hybrid integrated amp represents the culmination of years of solid state and tube preamp/amplifier design. Modwright has from it's very beginning preferred a hybrid approach to system building. Combining the natural richness of tube preamplifiers with the grip and punch of solid state amplification.
The KWh 2225i hybrid integrated amp is a natural extension of this philosophy. Combining the solid state output stage of Modwright's Reference KWA 150SE amp, with the controls and integration of the KWI 200, then replacing the KWI 200 solid state preamp circuit with a Class A tube design and increasing the power to 225W. The result is the KWH 225i.
Our Take on the KWH 225i
This is perhaps Dan's best work yet. The KWH 225i has gobs of power for when you need it, but is biased to run in Class A for the first 25 watts. This means that for most of your quite to moderate level listening, you are in Class A mode, only slipping in to Class A/B when you turn it up to louder levels. The tube preamplifier section is dead quiet. We actually preferred the stock JJ 6922 tubes to the more expensive Ampex. Dan voiced the amp for just the right balance of warmth and neutrality. Wonderful tone and dynamics, holographic soundstaging and pinpoint imaging. We rarely run it out of Class A mode due to the 97 dB efficiency of the Spatial X3's. The integrated itself runs warm, not hot at all due to ample heat sinking.
The Modwright KWH 225i closes the performance gap between separates and integrated amplifiers. You really need to hear this!
Class A Operation, Zero Negative Feedback
The Class A preamp stage, with 25 watts of zero negative feedback Class A output from the amplifier section will be a fantastic match for efficiency speaker designs. Even lower efficiency speakers will benefit from the high current 225 watts of Class A/B output.
- Three sets of RCA inputs.
- One set of XLR inputs.
- One Home Theater Bypass Input (HTBP)
- Optional SS phono stage (user installable).
- Front panel controls: Input select, power, volume and HTBP.
- Remote control functions: Power, volume, mute, input select, dim/turn off displays.
- Tube Complement: (2) 6922/6dj8/7308.
- Class AB operation, biased into Class A for the first 25W.
- Zero negative feedback.
- Input Impedance: 20K
- Gain: 32dB
- Frequency Response: 20Hz-100Khz (-1dB at 100Khz).
- Dimensions: 17“Wx17“Dx6.5“H
- Weight: 60 lbs